SignalTraffic Forums
For the discussion of Traffic Signals, Signs and other street furniture
NEMA Conflict monitor overlap programming cards
Moderator: SignalLab
3 posts
• Page 1 of 1
NEMA Conflict monitor overlap programming cards
by jab8356 on Sat Dec 15, 2012 7:09 pm
Are they pretty much standard and interchangeable? I'm getting ready to take my plywood cabinet out of service and put in service the NEMA cabinet I got from Drew over Thanksgiving. I run two overlaps and I was thinking I would have to solder the correct connections on the new monitor's card, but then a light bulb went off and I decided to see if they were interchangeable. They are very close, but not exact, but both seem to seat correctly in either monitor.
-
jab8356 - Crusty Old Salt
- Posts: 3182
- Joined: Wed Aug 17, 2011 3:34 am
- Location: Macomb County, Michigan
Re: NEMA Conflict monitor overlap programming cards
by TacomaJoe on Sat Dec 15, 2012 7:15 pm
NEMA defines the dimensions and circuits, the boards are interchangeable.
Joe N
-
TacomaJoe - Crusty Old Salt
- Posts: 2550
- Joined: Mon Oct 12, 2009 8:48 pm
- Location: Tacoma, WA
Re: NEMA Conflict monitor overlap programming cards
by EPAC-EPIC-MARC on Sat Dec 15, 2012 7:16 pm
They should fit and operate the same, the monitor just would not use the channel outputs for 7-12. 
EDIT: Joe beat me to it!
EDIT: Joe beat me to it!
-Nick B.
Shelby Twp. MI, The Northern Fringe of the Metro-Detroit Region
Click Here for Photos of my Traffic Signal Collection
Shelby Twp. MI, The Northern Fringe of the Metro-Detroit Region
Click Here for Photos of my Traffic Signal Collection
-
EPAC-EPIC-MARC - Crusty Old Salt
- Posts: 5846
- Joined: Thu Oct 23, 2008 6:17 pm
- Location: Shelby Township, MI
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: SignalFreak and 0 guests